Elektrika ST-registered contractor
EN BM
Contact us →

Services · Lighting

Lighting installation and LED retrofit

Whether you are looking for someone to pasang lampu in a new home or relight a factory floor, we plan the circuits, fittings and controls so the space is bright where it matters and your electricity bill goes the other way.

Scope of work

Lighting work for every type of space

Homes and shops

Pasang lampu rumah & kedai

  • LED downlights, panel lights, cove lighting, track and feature lighting installed with neat cut-outs and tidy wiring.
  • Dimmer, two-way and smart-switch wiring, including correct neutral at the switch for smart modules.
  • Replacement of old fluorescent fittings with LED, with driver and ballast removal done safely.
  • Outdoor, porch, gate and garden lighting with weatherproof fittings and protected circuits.

Offices and factories

Pejabat & kilang

  • LED high bay and linear high bay installation at height, using scaffolding or scissor lifts where required.
  • Lux level survey to check the work area against recommended illumination before and after the retrofit.
  • Zoned switching and sensors so unused areas are not lit all day.
  • Retrofit planning that limits downtime on production lines.

Safety lighting

Lampu kecemasan

  • Emergency lighting and exit signs with correct battery backup, fed from a dedicated unswitched circuit.
  • Maintenance testing of existing emergency fittings and replacement of failed batteries.
  • Lighting circuits protected by RCD with labelled DB schedules.
  • Documentation of fittings, wattage and circuits for your records and energy planning.

How we work

From survey to handover

STEP 1

Survey and lux check

We note existing fittings, ceiling type, mounting height and, for work areas, measure current lux levels.

STEP 2

Layout and quotation

Fitting type, quantity, circuits and any DB changes set out in writing.

STEP 3

Installation

Old fittings removed, new circuits and fittings installed with neat finishing.

STEP 4

Test and handover

Circuits tested, emergency lighting checked and lux readings repeated where applicable.

FAQ

Frequently asked questions

How much does LED lighting save compared with fluorescent?
LED fittings typically use significantly less power than T8 fluorescent or metal-halide lamps for similar light output, and last far longer. The saving depends on operating hours, so we estimate it for your site.
Can you install high bay lighting in a factory?
Yes. We install LED high bay and linear fittings at height using the right access equipment, and plan the work to limit disruption to production.
Do smart switches work with any house wiring?
Many smart switches need a neutral wire at the switch box, which older Malaysian houses do not always have. We check this at the survey and tell you what is possible before you buy.
Is emergency lighting required?
Commercial and industrial buildings generally need emergency lighting and exit signs under fire safety requirements. We install and test them, and can advise on what your premises should have.
Do you supply the lights?
Both ways work. We can supply and install, or install fittings you have bought. We will warn you if a chosen fitting is unsuitable for the ceiling or circuit.

Get a quote

Get a quote for lighting installation

Fill in the short form — we open WhatsApp with your details prefilled. Or WhatsApp / call us directly.

Better light, lower bills. Free site visit & quote.

Free site visit & quote · registered contractor · tested & documented.

Petaling Jaya · Kuala Lumpur · Puchong · Shah Alam · Klang · Subang Jaya · Kajang · Cheras · Ampang · Cyberjaya · Seremban · Kota Damansara · Kepong · Setia Alam · Bangi